FAS International SKUDO Mode D'emploi page 73

Les langues disponibles

SKUDO – Issue 00

9.1.3

TO SET MACHINE PARAMETERS

Command 49 Enabling/Disabling spirali slave:

This command enables the master/slave connection. It is possible to connect up to two slave snack

machines. Command 40 must be set after the connected slave machines have been enabled.

Command 50 Enter machine code:

The user is asked to enter a numeric code with max. 8 digits, which is used as the identification code when

the programming of the parameters is carried out using the key system.

Command 58 Enabling the Slave mode from Stand-Alone:

To set the following option ONLY, you must press the "Programming Button" twice

consecutively, signalled by the sound of the buzzer, to access the second menu level.

The display shows "Command 00". To exit programming mode, press the button "A".

This is used to run a Stand-Alone as a Slave. If the command is set at 1, the following operations must be

carried out.

Switch off the machine by means of the main switch and pull out the power plug.

disconnect the connector JP9 connected to the main card.

make the Master/Slave connection by means of the serial cable, fitting the connectors to the sockets on the

rear.

nominate the machine as "SLAVE A" or "SLAVE B" by means of the dip-switch on the electrical panel,

positioning the notch in the respective position as in the figure below. To access the electrical panel, see the

paragraph: ACCESS TO THE ELECTRICAL PANEL AND COOLING UNIT.

SLAVE

turn on again, and carry out the programming of the Master machine.

Command 59 Stroke counter :

If the command is set at 1, the stroke counter appears every time the door is opened.

FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it

SLAVE