Table des Matières
Publicité
Connection and Operating Elements
See image on the fold-out page.
(1)
ON/OFF switch (POWER)
Turn the mixing desk on and off with this switch. The appliance is turned on when the
switch is in the "ON" position. When the appliance is turned on, the first LEDs of the
recording level indicator (9) light up.
The power pack still consumes small amounts of energy when the on/off switch is in
the position "OFF". In order to completely separate the appliance from the electricity
net, you have to pull the power pack out of the outlet.
(2)
Headphone volume controller (CUE LEVEL)
With this controller, you adjust the volume of the connected headphones. Position
"0" is the minimum, position "10" the maximum headphone volume.
(3)
Gain controller (GAIN)
With this controller, you adjust the input level of the signals. Position "0" is the mini-
mum, position "10" the maximum volume.
The controller GAIN "CH1" controls channel 1 (phono and line), controller GAIN
"CH2" channel 2 (phono and line).
(4)
Stereo fader
With these controllers, you set the output levels of channels 1 and 2. Position "10" is
the maximum volume. The controller "CH1" controls channel 1 (phono and line), con-
troller "CH2" channel 2 (phono and line).
(5)
Headphone socket
You can plug stereo headphones with a minimum impedance of 8 Ohm into this 6.3
mm socket for pre-listening.
(6)
"TALK OVER" switch
With this switch, you can attenuate the signal of the LINE and PHONO inputs when
making announcements over the microphone.
When set to "ON", the volume of the output signal is attenuated.
(7)
Microphone input controller
This controller sets the microphone level.
In position "0", the microphone volume is at its minimum, in position "10" at its max-
imum.
26
All manuals and user guides at all-guides.com
Symptom
No signal to be heard
although the recording
level indicator shows a
signal.
The sound is too low.
There is a humming
sound.
One channel does
not work.
Possible cause
Error remedy
The subsequent appliance Check the subsequent
is not turned on or
appliance and select the
adjusted wrongly.
right input on the
amplifier.
Output wrong or not
Connect the output as
connected.
described.
In/output level is adjusted
Adjust the in/output level
wrongly.
as described.
The talk over switch (6)
Only use the talk over
is on.
switch when you want
to make an announcement
with the microphone.
Fader/gain slider is
Adjust the fader/gain
wrongly adjusted.
slider correctly.
A cable is defect.
Exchange the cable.
There is a humming loop
Connect the signal
between the connected
ground with a specially
appliances.
ground-insulated cable.
Attention! Do not
interrupt the protective
earth connection of the
voltage supply!
A cable has become
Check the connections
lose.
between the
appliances.
35
Publicité
Table des Matières
