Conrad Electronic DJ 1/2 Mode D'emploi page 13

Symptom Possible cause
The balance controller
was shifted on the
amplifier.
Sound is distorted. The connected appliance
does not meet the
required specifications
for a cinch connection or
does not have a cinch
connection.
Gain slider is wrongly
adjusted, the mixing
desk is oversteered.
Other repairs than the ones described above may only be per-
formed by an authorized expert.
36
All manuals and user guides at all-guides.com
Error remedy
Adjust the balance
controller.
Use appliances with a
proper cinch connection.
Adjust the gain slider as
described.
Ensure that the appliance/power pack are sufficiently ventilated.
When opening the covers or removing parts except where possible by hand, you
may expose live parts. Connections may also be live. Prior to aligning or repair work
or exchanging parts or modules, you must separate the appliance from all power
sources if you need to open it. Only an expert familiar with the risks and the pertinent
regulations may repair or maintain an open live appliance.
Never plug in the power pack immediately after bringing it from a cold room into a
warm room. The condensation may destroy the appliance under adverse circum-
stances. Leave the appliance turned off until it has reached room temperature. Wait
until the condensation has evaporated.
Also observe the safety notices and operating instructions of your remaining music
appliances.
The appliance is not designed for industrial or commercial use.
Do not put any open fire sources like burning candles etc. onto the appliance.
Only use the appliance in moderate climate, not in a tropical climate.
Avoid operating the appliance under adverse ambient conditions, e.g. dust and flam-
mable gasses, excessively high (>+50°C) or low (<+10°C) ambient temperatures.
If you are not certain how to connect the appliance correctly or in case
of any questions not covered by the operating manual, please contact
our technical information service or another expert. Please contact an
expert in case you have any doubts about the mode of operation or
the safety of the product.
25