Electrolux EWF 128500 W Notice D'utilisation page 24

24 electrolux
6. Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
POSITIONING
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or other kitchen units. Level
the washing machine by raising or lowering
the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the
machine MUST be level and stable. If nec-
essary, check the setting with a spirit level.
Any necessary adjustment can be made
with a spanner.
Accurate levelling prevents vibration, noise
and displacement of the machine during
operation.
All manuals and user guides at all-guides.com
x4
x4
Caution! Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor. After having
levelled the appliance, tighten the lock
nuts.
RUBBER FEET KIT (4055126249)
Available from your authorized dealer.
The rubber feet are particularly recommen-
ded on floating, slippery and wooden floors.
Mount the rubber feet to prevent vibration,
noises and displacement of the appliance
during operation.
Read carefully the instructions supplied with
the kit.
WATER INLET
Warning! This appliance must be
connected to a cold water supply
Caution! Before connecting up the
appliance to new pipework or to
pipework that has not been used for
some time, run off a reasonable
amount of water to flush out any debris
that may have collected
Caution! Do not use the hose from
your previous appliance to connect to
water supply.
1. Connect the hose to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.