What To Do If - Electrolux EWF 128500 W Notice D'utilisation

20 electrolux
6. Screw the hose back to the machine
and make sure the connection is tight.
35°
7. Turn on the water tap.
FROST PRECAUTIONS
If the machine is installed in a place where
the temperature could drop below 0°C, re-
move the remaining water from the inlet
hose and the drain pump.
1. disconnect the mains plug from the
mains socket.
2. close the water tap
3. unscrew the water inlet hose from the
tap;
4. put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
5. empty the drain pump as described in
the 'Emergency emptying out' section.
6. when the drain pump is empty, install
the water inlet hose again.
Warning!
Make sure that the temperature is more
than 0 °C before you use the appliance
again.

WHAT TO DO IF...

Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the red pilot light of button 8 blinks, one of
the following alarm codes appears on the
display and some acoustic signals sound
All manuals and user guides at all-guides.com
45°
The manufacturer is not responsible for
damages caused by low temperatures.
EMERGENCY EMPTYING OUT
If the water is not discharged, proceed as
follows to empty out the machine:
1. Pull out the plug from the power sock-
et.
2. Close the water tap.
3. If necessary, wait until the water has
cooled down.
4. Open the pump door.
5. Place a bowl on the floor.
6. Unscrew carefully the filter. When the
bowl is full, screw the filter again.
– The water drain out by gravity into
the bowl.
– Empty the bowl.
– Repeat the procedure until water
stops flowing out.
7. Clean the pump if necessary as previ-
ously described.
8. Screw firmly the filter again and close
the door pump.
Important! Every time you drain the water
through the emergency emptying hose you
must pour 2 litres of water into the main
wash compartment of the detergent drawer
and then run the drain programme. This will
activate the ECO Valve device avoiding
that part of the detergent remains unused
at next washing.
every 20 seconds to indicate that the ma-
chine is not working:
•
: problem with the water supply.
•
: problem with the water draining.
•
: door open.
Once the problem has been eliminated,
press the button 8 to restart the pro-
gramme. If after all checks, the problem
persists, contact your local Service Centre.