Console - Batavus C3 Mode D'emploi

If you want to measure your heart rate this way
during your workout, moisten the grooved
electrodes on the transmitter belt with water.
Fasten the transmitter just below the chest with the
elastic belt, firmly enough so that the electrodes
remain in contact with the skin while training, but
not so tight that normal breathing is prevented.
If you wear the transmitter and belt over a light
shirt, moisten the shirt slightly at the points where
the electrodes touch the shirt. The transmitter
automatically transmits the heart-rate reading to
the meter up to a distance of about 1 meter. The
heart-rate value is displayed in the meter. Follow
your heart rate during the training.
REMARKS ON TELEMETRIC MEASUREMENT
If the electrode surfaces are not moist, the heart
rate reading will not appear on the display. If the
electrodes are dry, they must be moistened again.
Allow the electrodes to warm up properly to
ensure accurate heart-rate measurement. If there
are several telemetric heart rate measurement
equipments next to each other, the distance
between them should be at least 1,5 m. Similarly,
if there is only one receiver and several transmitters
in use, only one person with a transmitter should
be within transmission range. The transmitter is
switched to an active state only when it is being
used for measurement. Sweat and other moisture
can, however, keep the transmitter in an active state
and waste battery energy. Therefore it is important
to dry the electrodes carefully after use. When
selecting training attire, please note that some
fibers used in clothes (e.g. polyester, polyamide)
create static electricity, which may prevent reliable
heart rate measurement.
Please note that a mobile phone, television and
other electrical appliances form an electro-magnetic
field around them, which will cause problems in
heart rate measurement.
All manuals and user guides at all-guides.com

CONSOLE

BUTTONS
1. ENTER
Selects and confirms console functions
2. +/- BUTTONS
Adjusts resistance (Level) and selects the profile
3. RESET
Resets the set values
4. START/STOP
Starts, pauses and stops training. During training,
pressing this button once activates the Pause mode.
Pressing the button again starts the program again.
5. RECOVERY
Calculates your fitness index
FUNCTIONS
1. TIME
The training time counts up, starting at 00:00, and
runs to 99:59 minutes. Then the time begins again
at 00:00. The colon (:) will blink once per second.
2. SPEED
The speed is displayed up to 99.9 km/h.
Revolutions The crank arm revolutions are
displayed in rpm (revolutions per minute)
•
O W N E R ' S M A N U A L B A T AV U S C 3
G B
7