Medtronic Guardian Connect MMT-7821 Manuel D'utilisation page 12

Pairing your transmitter
Always refer to the system user guide for instructions on how to pair your transmitter to
your mobile device.
Inserting the sensor
Always refer to your serter user guide for instructions on how to insert the sensor.
Connecting the transmitter to the sensor
Before proceeding, have your system user guide available.
To connect the transmitter to the sensor:
1 After the sensor is inserted, consult your serter user guide for details on applying the
required tape before connecting the transmitter.
2 Hold the rounded end of the inserted sensor to prevent it from moving during
connection.
3 Hold the transmitter as shown. Line up the two notches on the
transmitter with the side arms of the sensor. The flat side of the
transmitter should face the skin.
4 Slide the transmitter onto the sensor connector until the sensor
arms snap into the notches on the transmitter. If the transmitter
is properly connected, and if the sensor has had enough time to
become hydrated, the green light on the transmitter will flash 6
times.
Note: If the transmitter does not flash, see Troubleshooting, on page 19.
5 When the transmitter light flashes green after connecting to the sensor, follow the
prompts on the app to select new or existing sensor. For more instructions, see your
system user guide.
6 Attach the adhesive tab of the sensor to the transmitter.
7 Refer to the serter user guide for instructions on how to apply additional tape if
necessary.
8 Follow the instructions that appear on the app or follow the instructions in your
system user guide.
-6-