Electrolux ESV243C1WAI Manuel D'utilisation page 7

4.2 Location of the Remote Controller
Max. 8m
4.3 Battery installation/replacement
• Keep the remote controller where its
signal can reach the receiver of the
indoor unit (a maximum distance of
8 m is allowed).
• When the remote controller sends
out a signal, the symbol
on the display. The indoor unit will
acknowledge the signal with a beep
sound when it receives an effective
signal.
• Remove the back cover from the
remote controller, exposing the
battery compartment and insert two
new alkaline dry batteries (2x AAA 1.5
Volt). Make sure that the polarity of (+)
or (-) is installed correctly.
• Slide the battery compartment cover
back on.
• When changing batteries, do
not use old or varied ones,
otherwise, it may cause
problems with the remote
controller.
• If the remote controller is not
used for a long time, remove
the batteries as old batteries
may leak or corrode and
damage the remote controller.
• The battery life during normal
use is about six months.
• If the remote controller does
not operate normally, please
remove and refit the batteries. If
abnormal operation continues,
replace with new batteries.
ENGLISH 7
will blink