Indoor Unit Display; Remote Controller - Electrolux ESV243C1WAI Manuel D'utilisation

6 www.electrolux.com

3. INDOOR UNIT DISPLAY

4. REMOTE CONTROLLER

4.1 How to use the Remote
controller
1. Keep the remote controller where its
signal can reach the receiver of the
indoor unit.
2. When operate the air conditioner, make
sure the remote controller is pointing to
the signal receiver of the indoor unit.
3. When the remote controller sends out
a signal, the symbol
display of the remote controller.
4. The indoor unit will acknowledge the
signal with a beep sound when it
receives the signal from the remote
controller.
5. Please press the button of the remote
controller and resend the signal if you
did not hear a beep sound from the
indoor unit.
1 2
will blink in the
1 TEMPERATURE indication lamp
• Displays the setting or room temperature
when the unit is operational.
• Displays the malfunction code when fault
occurs.
• Displays the feature code when some
feature is activated.
2 Wireless indication lamp (optional)
• Lights up when Wireless feature is
activated.
**Feature code in indoor unit display
" " Displays for 3 seconds when Timer on is
set or the feature Swing, Turbo or Quiet
is turned on.
" " Displays for 3 seconds when Timer off is
set or the feature Swing, Turbo or Quiet
is turned off.
" " Displays when anti-cold air feature is
turned on.
" " Displays when unit is in defrosting.
" " Displays when Self Clean feature is
turned on (Inverter split type).
Displays when unit is in self-cleaning
(Fixed-speed type).
" " Displays when 8
turned on (some units).
• The air conditioner will not
operate if curtains, doors or
other materials block the signals
from the remote controller to the
indoor unit.
• Prevent any liquid from falling
into the remote controller. Do not
expose the remote controller to
direct sunlight or heat.
• If the infrared signal receiver on
the indoor unit is exposed to
direct sunlight, the air conditioner
may not function properly. Use
curtains to prevent the receiver
being exposed to sunlight.
• If other electrical appliances react
to the remote controller, either
move these appliances or consult
your local dealer.
C heating feature is
0