Electrolux ESV243C1WAI Manuel D'utilisation page 17

is less than 24 C/75
0
temperature is above 24
the button, the fan speed will change
to Auto, the set temperature will remain
unchanged.
• Pressing the ECO button, or
modifying the mode or adjusting
the set temperature to less
than 24 C/75
0
operation.
• Under ECO operation, the
set temperature should be
24 C/75 F or above, it may result
0 0
in insufficient cooling. If you feel
uncomfortable, just press the
ECO button again to stop it.
GEAR function: Press the button to active
the GEAR function, 75% means up to
75% electrial energy consumption and
50% means up to 50% electrial energy
consumption.
• Under GEAR operation, the
display on the remote controller
will alternage between electical
energy consumption and set
temperature.
6. Breeze Away function
(optional)
Press the Breeze Away button to active
the function. This feature avoids direct air
flow blowing on the body and makes you
feel indulging in silky coolness.
7. Fresh function (optional)
Press the Fresh button to active the Health
function. When the function is initiated, the
Ionizer/Plasma Dust Collector(depending
on models) is energized and will
help to clean the air. This function is
recommended when the indoor air quality
is in bad condition.
8. Sleep function
When you press the Sleep button,
the economic running function will be
activated, the set temperature will increase
(cooling) or decrease (heating) by 1ºC(2ºF)
per hour over a 2 hour period. The final
F). If the set
0
C/75 F, press
0 0
F will stop ECO
0
temperature will then be maintained till
further changes made by the user.
The SLEEP function is not available
in FAN or DRY mode.
Set
1ºC
Tem.
Cooling
1hour
Set
Tem.
Heating
1hour
9. Follow Me function
Keep pressing Turbo button for more than
7 seconds to activate memory feature
of Follow Me function. The Follow Me
function enables the remote control to
measure the temperature at its current
location and send this signal to the air
conditioner every 3 minutes interval. When
using AUTO, COOL or HEAT modes,
measuring ambient temperature from
the remote controller (instead of from
the indoor unit itself) will enable the air
conditioner to optimize the temperature
around you and ensure maximum comfort.
• If the memory feature is activated,
"ON" displays for 3 seconds on
the screen.
• Press the Set and OK buttons to
inactivate the Follow Me feature,
refer to Set function desctription
for the details.
• If the memory feature is
inactivated, "OF" displays for 3
seconds on the screen.
• While the memory feature is
activated, press the ON/OFF
button, shift the mode or power
failure will not cancel the Follow
me function.
ENGLISH 17
1ºC
1hour
1ºC
1ºC
1hour