Kemper 6541091 Mode D'emploi page 17

Parts supplied
•
Stand (B) with LPG tank housing (C)
•
Assembly post (D) with 2 pcs post brackets (E) and 1-piece post bracket (F) with band for fixing the
cylinder
•
Complete burner (G)
•
3 pcs bolts M8x16 mm (A – 1) for assembly post brackets and stand
•
6 pcs bolts M6x35 mm (A – 2) and 6 pcs nuts M6 (A – 3) for assembly post and post brackets.
•
3 pcs pins for burner (A – 4)
•
Reflector (H) 81 cm with 9 pcs screws, 9 nuts and 9 washers for the reflector's assembly end 9 pcs
washers  8 (A – 5) and 3 pcs castle nuts (A – 6) for assembly the reflector on the burner.
•
4 pcs bolts M6x10 mm (A – 7) for assembly post and burner.
•
3 pcs ground fixer (A – 9)
•
6 pcs bolts M6x10 mm (A – 7), 6 pcs nuts M6 (A – 3) e 6 pcs washers (A – 8) for assembly the ground
fixers on the stand.
•
Hose connection (A – 10) and gasket (A – 11)
Options
•
1,5 m flexible hose (J
•
Pressure regulator with threaded output (L
•
1,5 m flexible hose (J
•
Pressure regulator without threaded output (L
DT ISTR_6541091_04/21_REV.1 12/21
ASSEMBLY PARTS
) with threaded connection and seal (M).
1
1
) without threaded connection and hose clamps (N).
2
) for hose with fitted connection (J
) for hose without fitted connection (J
2
17/60
).
1
).
2