Instructions For Assembly; Handling The Equipment; Care And Maintenance - Kettler REGATTA 300 Mode D'emploi

• RO1031-100 Regatta 500
Attention: Operation and storage below 3°C / 37.4°F not permitted.

3.0. INSTRUCTIONS FOR ASSEMBLY

⚠
R ISK! Ensure that your working area is free of possible sources of danger, for example don't leave
any tools lying around. Always dispose packaging material in such a way that it may not cause any
danger. There is always a risk of suffocation if children play with plastic bags!
⚠
W ARNING! Please note that there is always a danger of injury when working with tools or doing
manual work. Therefore please be careful when assembling this machine.
• Ensure that you have received all the parts required (see check list) and that they are undamaged.
Should you have any cause for complaint, please contact your KETTLER dealer.
• Before assembling the equipment, study the drawings carefully and carry out the operations in the
order shown by the diagrams. The correct sequence is given in capital letters.
• The equipment must be assembled with due care by an adult person. If in doubt call upon the help
of a second person, if possible technically talented.
• The fastening material required for each assembly step is shown in the diagram inset. Use the
fastening material exactly as instructed.
• Bolt all the parts together loosely at first, and check that they have been assembled correct-
ly. Tighten the locknuts by hand until resistance is felt, then use spanner to finally tighten nuts
completely against resistance (locking device). Then check that all screw connections have been
tightened firmly. Attention: once locknuts have been unscrewed they no longer function correctly
(the locking device is destroyed), and must be replaced.
• For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of
tubing plugs).

4.0. HANDLING THE EQUIPMENT

• Before using the equipment for exercise, check carefully to ensure that it has been correctly as-
sembled.
• It is not recommended to use or store the apparatus in a damp room as this may cause it to rust.
Please ensure that no part of the machine comes in contact with liquids (drinks, perspiration etc.).
This may cause corrosion.
• The machine is designed for use by adults and children should not be allowed to play with it. Chil-
dren at play behave unpredictably and dangerous situations may occur for which the manufacturer
cannot be held liable. If, in spite of this, children are allowed to use the equipment, ensure that
they are instructed in its proper use and supervised accordingly.
• The rowing machine is a training device which works on a stroke rate dependent basis (speed-de-
pendent).
• A slight production of noise at the bearing of the centrifugal mass is due to the construction and
has no negative effect upon operation.
• RO1030-100 Regatta 300, RO1028-100 Rower 2.0
The training device has a magnetic brake system.
• RO1031-100 Regatta 500
The training device has a water brake system.
• To operate correctly, the pulse function requires a minimum voltage of 2,7 volts (only for compu-
ters working with batteries).
• Before beginning your first training session, familiarize yourself thoroughly with all the functions
and settings of the unit.

4.1. Care and Maintenance

• Damaged components may endanger your safety or reduce the lifetime of the equipment. For this
reason, worn or damaged parts should be replaced immediately and the equipment taken out of
ROWERS |
ENGLISH 9
EN