Ibiza Light LSM1200PRO Manuel D'utilisation page 4

- Don't spray it to people directly and far away fire.
- The temperature of sprayer is very high so that keep the space between machine and other material
things more than 300cm.(40
- The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
- The unit should only be used in moderate climates
- Don't add tinder liquid such as oil, gas, perfume and etc. into the fog machine.
- Pay attention to all notices sign and operation instructions on all machines.
- Check regularly if the tank contains enough fog liquid.
- Empty the tank before transport.
- Don't drink fog liquid otherwise you need to consult a doctor immediately. Use clean water to wash skin
and eyes once fog liquid touches them.
Installation and Use
• Unpack the fog machine.
• Connect the lead of the wired remote control with the 5-pin plug to the rear of the smoke machine.
• Fill the fluid tank by means of a funnel.
• Plug the smoke machine into a mains outlet.
• Turn the switch to "ON" and the machine will heat up. The green LED on the remote control light up green
when the machine has reached the working temperature.
• Adjust the OUTPUT button.
• Push the green button once and the smoke machine will produce a thick fog. Press the button as long as
you need fog.
• If the red LED lights up, the smoke machine has to heat up again to reach its working temperature.
• The unit can be controlled via a wired remote control or a wireless remote control fitted with 2 buttons.
Repair:
- Please clean the fog machine regularly to avoid damage of parts.
- Don't let the fog machine become dirty. Screw the cover of liquid can after addition of fog liquid.
- After about 40 hours of continuous use, please use 80% distilled water and 20% vinegar to clean the
refractory pipe.
- Disassemble the spray mouth and use vinegar to clean it
- Reequip the spray mouth after cooling down and add fog liquid for next use.
DMX512 Connection & Operation
Please use a standard 3-pin XLR lead to connect the fog machine to your controller. The XLR plus is wired as
follows: 1= Earth; 2= negative; 3= positive
Avoid cable runs that are longer than 100m in order to avoid signal loss and interference from other units.
Address setting
The unit has 1x DMX channel. The DMX512 address ranges from 0-255.
©Copyright Lotronic 2014
C—80 C)
0 0
Page 4