Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
AUTOMATIC OVEN CLEANING
For the description of this function, see the chapter CLEANING and the functions table at page 14.
Pyro Express
Pyro
3 hours high temperature cleaning
To activate the oven's automatic cleaning cycle (pyro-cleaning), proceed as follows:
1.
Use the "Functions" knob to select "Cleaning". The display shows "Pyro Express" and "Pyro".
2.
Select one of the two cycles using the "Browse" knob. Confirm by pressing
3.
Turn the "Browse" knob to position the cursor at START, then confirm by pressing button
1/3
Please switch off cooktop
above oven and press
✓
4.
The display shows the instructions to be followed in order to start the cycle. After following each
instruction, confirm with button
Door will be locked
during cleaning
5.
Upon the final confirmation, the oven starts the cleaning cycle and the door is automatically locked: a
warning and the symbol
afterwards, the display shows a progress bar indicating the cleaning cycle progress.
N.B.: If the oven door is opened before it is unlocked automatically, a warning message appears
on the display. When the door is reclosed, the cycle must be started again by pressing button .
- 00:00
TIME
Finished
15:00
END TIME
6.
At the end of the cycle, the relative message flashes on the display, after which the cooling bar
indicates cooling in progress. The residual temperature is indicated on the display together with the
symbol
. The door remains locked until the temperature inside the oven has returned to an
acceptably safe level: the display shows the time of day.
- 03:00
TIME
Cleaning
15:00
END TIME
2/3
Please remove all accessories
from the oven and press
✓
.
- 02:59
TIME
Cleaning
15:00
END TIME
are shown on the display for around three seconds. Immediately
257°
Cooling Down
GB13
3/3
Remove stains from glass
with moist sponge and press
Please close door
18:32
.
.
✓
Publicité
Table des Matières
