Publicité
Les langues disponibles
Les langues disponibles
SM 1619X03849 11-08:SM 1619X03849 11-08 11/21/08 10:21 AM Page 13
b. Check to see if outlet is connected to a
light switch which turns power "off" when
lights are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab if necessary.
BATTERy CHARGE CONDITION
INDICATOR LIGHTS
(SB18A & SB18B BATTERIES)
Your battery pack is equipped with charge
condition indicator lights (Fig. 8). The indicator
lights shows the charge condition of the
battery during operation.
To check battery charge condition, depress
and hold the button on the backside of the
battery pack.
CHARGING BATTERy PACK
(SC118 OR SC118B CHARGER)
Plug charger cord into your standard power
outlet, then slide the battery pack into charger
(Fig. 8).
The charger's green indicator will begin to
"BLINK". This indicates that the battery is
receiving a fast charge. Fast-charging will
automatically stop when the battery pack is
fully charged.
When the indicator light stops "BLINKING"
(and becomes a steady green light) fast
charging is complete.
BUTTON
B TTERY
CH RGE
CONDITION
INDIC TOR
LIGHTS
d. If you still do not get proper charging,
take or send tool, battery pack and charger
to your local Skil Service Center.
Note: Use of charger's or battery packs not
sold by Skil will void the warranty.
• • • • • When all five lights are illuminated,
this indicates the batter pack is fully charged.
• • • When only three lights illuminate, this
indicates the battery pack is partially charged.
•
When only one light illuminates, this
indicates the battery pack is slightly charged.
When no lights illuminate, this indicates the
battery pack is completely discharged.
When you begin the charging process of the
battery pack, a steady green light could also
mean the battery pack is too hot or too cold.
The purpose of the light is to indicate that the
battery pack is fast-charging. It does not
indicate the exact point of full charge. The
light will stop blinking in less time if the
battery pack was not completely discharged.
When the battery pack is fully charged,
unplug the charger (unless you're charging
another battery pack) and slip the battery
pack back into the tool handle.
B TTERY
P CK
-13-
FIG. 8
CH RGER
INDIC TOR LIGHT
Publicité
