Publicité
Les langues disponibles
Les langues disponibles
SM 1619X03849 11-08:SM 1619X03849 11-08 11/21/08 10:21 AM Page 11
POCKET/PLUNGE CUTS
The reciprocating saw can be used to make
plunge cuts into softer material, (for example,
wood or light building materials for walls),
without a starting hole (Fig. 5).
1. Move the orbit selector lever toward the
word STANDARD.
2. Mark the line to be cut clearly on the work.
3. Set the tool with one edge of the footplate
firmly against the material.
4. Place the tip of the blade (not running) on
the line to be cut.
5. Tilt the saw so that the blade clears the
work.
6. Squeeze the trigger switch and carefully
engage the moving saw blade into the
material.
RELEASING AND INSERTING
BATTERy PACK
Release battery pack from tool by pressing
the battery release button and sliding pack
IMPORTANT CHARGING NOTES (LITHIUM-ION BATTERIES)
1. The charger was designed to fast charge
the battery only when the battery temperature
is between 32˚F (0˚C) and 113˚F (45˚C). If the
battery pack is too hot or too cold, the charger
will not fast charge the battery. (This may
happen if the battery pack is hot from heavy
use). When the battery temperature returns to
between 32˚F (0˚C) and 113˚F (45˚C), the
charger will automatically begin charging.
2. A substantial drop in operating time per
charge may mean that the battery pack is
nearing the end of its life and should be replaced.
3. Remember to unplug charger during storage
period.
4. If battery does not charge properly:
7. After the blade penetrates through the work,
continue sawing along the marked outline.
To make plunge cutting easier, use a heavy
gauge blade, install the blade with the teeth
facing upward, and hold the saw upside down
as shown (Fig. 6).
Do not plunge cut in metal surfaces.
In thick materials and in harder materials, such
as metal, plunge cutting should not be
attempted. Such materials can be cut with the
recip saw only by starting the cut from the
edge of the material or from a hole drilled all
the way through the material that is large
enough to fit the saw blade.
W RNING
may create a hazard.
FIG. 5
out of handle base (Fig. 1). To insert battery,
align battery and slide battery pack into tool
until it locks into position. Do not force.
a. Check for voltage at outlet by plugging in
some other electrical device.
b. Check to see if outlet is connected to a
light switch which turns power "off" when lights
are turned off.
c. Check battery pack terminals for dirt.
Clean with cotton swab and alcohol if
necessary.
d. If you still do not get proper charging,
take or send tool, battery pack and charger to
your local Skil Service Center. See "Tools,
Electric" in the Yellow Pages for names and
addresses.
Note: Use of chargers or battery packs not
sold by Skil will void the warranty.
-11-
NOTES:
The use of any accessories
not specified in this manual
FIG. 6
Publicité
