Quick TCD 1044 E Mode D'emploi Et D'installation page 18

OPERATING
EN
REMOTE CONTROL ENABLING
To enable the remote control, press the enabling button and keep it pressed for at least 1 second.
After this period the enablement LEDs will start flashing with greater frequency and the control will emit a short sound.
Release the enablement button, the enablement LEDs will remain steadily lit on and the remote control will be enabled. In this
condition the control will emit a short sound every 5 seconds.
THRUSTER ACTIVATION
Bow thruster activation
When the propeller is activated the direction led corresponding to the imparted movement (red to the left, green to the right) will
light on and the control will emit an intermittent sound.
WARNING: once the direction joystick has been released, the boat will continue to move according to the inertia of the
movement.
18
To move the bow to the right, move the bow joystick
to the right at the end of its stroke.
To move the bow to the left, move the bow joystick to
the left at the end of its stroke.
TCD1044 E - REV003A