Drive Roll And Wire Guides Table; Setting Up And Making A Flux-Cored Weld - Lincoln Electric POWER MIG 180 DUAL Mode D'emploi

B-4
Wire Diameter &
Type
.025"(0.6mm) MIG wire .025"/.030" (0.6mm/0.8mm)
.030"(0.8mm) MIG wire
.035"(0.9mm) MIG wire .035"(0.9mm) Smooth Drive Roll
.030"(0.8mm) flux-cored .030"/.045" (0.8mm/1.1mm)
.035"(0.9mm) flux-cored
.045"(1.1mm) flux-cored
(See Figure B.6 for the following Items.)
12. CIRCUIT BREAKER – If the rated input current of
the machine is exceeded this circuit breaker will
trip. Press to reset.
13. GAS INLET – Shielding gas connects to this inlet.
14. POWER CORD CONNECTION - Ensure power
cord is diconnected from input voltage supply prior
to connecting or removing the cord from the
machine. Connect the circular connector present
on either input cord (120V or 230V) to the recepta-
cle on the back of the machine. The power cord
connector is secured to the receptacle by rotating
the connectorʼs coupling ring clockwise, until the
coupling ring latches on to the receptacle. Use
only the appropriate (120V or 230V) power cords
supplied by the Lincoln Electric Company.

SETTING UP AND MAKING A FLUX-CORED WELD

A. ITEMS NEEDED FOR
FLUX CORED WELDING
1. 035"(0.9mm) Contact Tip
2. .025"-.035"(0.6mm-0.9mm) wire
guide
INNER WIRE GUIDE
.025-.035 (.6-.9mm)
OPERATION
DRIVE ROLL AND WIRE GUIDES
Drive Roll
Smooth Drive Roll
Knurled Drive Roll
.030"/.045" (0.8mm/1.1mm)
Knurled Drive Roll
3. Knurled Drive Roll
4. .035"(0.9mm) NR-211MP Flux-
Cored Wire
POWER MIG® 180 DUAL
TABLE B.1
Drive Roll Part Inner Wire Guide
Number
KP2529-1
KP2529-2 (0.6mm-0.9mm)
Steel Wire Guide
KP2529-3
.045"(1.1mm) Steel
KP2529-3
13
12
Inner Wire Guide
Part Number
.025"-.035"
KP2531-1
KP2531-2
Wire Guide
FIGURE B.6
14
5. Black Flux Cored gun nozzle
6. Welding Gun
7. Work Cable & Clamp
B-4