PROMAT 4000873339 Mode D'emploi Original page 10

 The included power mains adaptor may only be connected to a power mains
socket (230V~/50Hz) which is according to regulations.
 The power mains adaptor may only be used indoors in dry rooms.
 Treat the product with care. Avoid mechanical shock, impact or dropping it
from any height. The product may be damaged.
 Do not disassemble the unit or attempt to modify or repair it yourself. It does
not contain parts serviceable by you. In case of questions or problems, turn
to our customer service.
Charging the Battery
Use the included power mains adaptor to connect the charging socket (3) of the
lamp to a 230 V~ 50 Hz wall socket or use the included vehicle adaptor to connect
it to the 12 or 24 Volt electric system of a vehicle or boat.
During charging the charging control light on the power mains adaptor lights up
red, when the charge is complete it lights up green.
The control light on the vehicle adaptor will stay red during the entire charging
process, after the charge is complete, the charger will turn off without the LED
changing colour. Charging will take at least 2.5 hours.
After charging, disconnect the lamp from the charging cable.
Intended Use
 The LED spotlight is intended for temporary illumination. It may be operated in
outdoor areas and can be exposed to rain (IP 65).
 Use the ON/OFF switch (4) on the battery housing to torn the spotlight on or off.
 No part of the product may be modified or converted!
 The safety instructions must be observed at all times!
Maintenance and Storing
Do not use aggressive chemicals, solvents or abrasives to clean the LED spotlight.
Do not allow liquids of any kind to enter the lamp or immerse the lamp in liquids of
any kind.
Store the lamp in a place away from direct sunlight, dust, humidity, extreme
temperatures and vibrations and out of the reach of children.
6
Operation