Informationen On Safety And Operation - Nemaxx 330 Manuel D'utilisation

IMPORTANT: The bow ring handle must not be used for towing, anchoring or mooring the boat.
For towing, use the appropriate towing eyelets on the starboard and port side of the boat. Attach the line
between the towing eyes in such a way that they are shaped like a reins. Attach a tow line to this reins and tow
the boat at low speed.
● CHECKLIST BEFORE COMMISSIONING.
● Check the air pressure in the air chambers.
● Remove all blockages from the self-draining floor drain.
● Check the outboard motor for safe mounting on the mirror.
● Check the fuel level and determine the range per level.
● Ensure that the outboard engine emergency stop switch is functioning properly.
● Ensure that the boat is not overloaded. Do not exceed the maximum number of passengers and payload.
Pay attention to the payload plate.
● Ensure that an approved lifejacket of the correct size is available for each person on board and that it is
easily accessible.
● Ensure that the paddles are in the boat in case of engine failure.
● The skipper knows the procedures for safe navigation, safe boating and safe outboard operation.
● A life belt or life cushion that can be thrown to a person in the water.
● Distribute passengers and cargo evenly throughout the boat. All persons must sit in designated seats or on
the floor.
● Instruct at least one passenger in the basic concepts of handling the boat and starting and operating the
outboard engine if the skipper is unable to operate the boat or falls overboard.
● Before sailing, inform someone of the destination of the trip and the expected time of return.
● Know the waters and the area. Know the tides, currents, sandbanks, rocks and other hazards.
● STABILITY AND BUOYANCY.
DISTRIBUTION OF PERSONS AND LUGGAGE
For safe operation, it is recommended that passengers sit in the middle of the boat whenever possible. It is
possible to sit on the sides of the boat if someone is sitting on the other side.
Make sure that loose equipment is securely fastened during the voyage.
All loads placed in the boat should be evenly distributed to ensure correct trim of the boat during operation..
INFORMATION ON SAFETY AND OPERATION.
[ EN ● 16 ]
Version: 1.2
KEN002ZB 02.02.2020