Seat Mounting; Inflate - Nemaxx 330 Manuel D'utilisation

7. Pump up the keel a little to lift the bottom plates off the floor.
8. Position the side joiners between the rubber stops
A - Paddle
B - Bottom plates
C - side profile (side joiner)
● SEAT MOUNTING
The seat must be fitted before the boat is fully inflated
Inflate the boat about three-quarters and insert the seat. Then inflate the boat fully.
● INFLATE
Valves
The inflatable valves are specially designed for safe and comfortable use. The valves are flat to increase
comfort in the boat and prevent damage to the boat.
Make sure the valve is tightly closed before using the boat.
Operating the valve:
● Remove the outer cap. The valve is closed when the middle propeller is in the upper position.
● To open the valve, press the valve bar once.
● To close the valve, press the valve stem again.
C
[ EN ● 11 ]
KEN002ZB 02.02.2020
B
A
Version: 1.2