Inflate inflatable boat
1. Inflate the side air chambers before inflating the keel air chamber. Pump the air chambers as follows.
NOTE: Insert the removable seat before the boat is fully inflated.
● Install the bottom plates into the boat. See Installing the Floor Plates.
● Unscrew the valve caps. Turn the caps a quarter turn counterclockwise.
● Make sure that the valve shafts are positioned in the closed position. Push in the valve stem and turn it
to the closed position.
● Connect the air hose adapter to the valve.
● Starting at one of the air valves, inflate the air chambers one by one to one-quarter of their capacity.
Repeat this procedure to fill all air chambers evenly until they are inflated to the recommended air
pressure of 0.25 bar (3.6 psi).
2. Unscrew the valve cap from the keel air chamber. Turn the cap a quarter turn counterclockwise. Make sure
that the valve stem is positioned in the closed position. Connect the air hose adapter to the valve. Inflate
the keel to the recommended air pressure of 0.35 bar.
3. After inflation, tighten the valve caps firmly (turn clockwise).
NOTE: Always monitor the air pressure in the air chambers. The air volume in the air chambers expands as the
internal air temperature increases. This causes the air pressure to fluctuate depending on water temperature
and weather conditions. After the boat has been inflated to the correct air pressure, the pressure may drop as
temperatures drop, requiring additional air. Direct sunlight or rising temperatures may cause the pressure to
become too high. In this case some air must be let out of the chamber until the recommended air pressure is
reached..
● PADDLE EQUIPMENT
Nemaxx inflatable boats are available in standard version with paddles or with oars, oarlocks and a rudder seat.
Install the bottom plates into the boat. See Installing the Floor Plates.
● Ensure that the seat is properly installed.
● If the oars are not used, they must be secured in the clamps on the side of the boat.
The arrangement of the oars on this inflatable boat ensures a comfortable position when rowing. Use the
bench provided to make rowing as comfortable as possible.
[ EN ● 13 ]
Version: 1.2
KEN002ZB 02.02.2020