solamagic Etherma Z1 Instructions De Montage Et D'utilisation page 77

Programming
Stand the heater vertically on a level substrate and connect to
the mains.
Important: Programming is only possible 180 seconds af-
ter connecting to the power!
Activating Press on the heater button for 5 seconds until a long signal
programming: tone is output (2 s).
If three short sequential signal tones are output, the heater is
outside the defined zero position.
Programming the zero position:
Press the heater button again for 2 seconds and then release
it. A long signal tone is output (2s).
Programming a timed switch-off:
It is possible to program a timed switch-off after 30, 60 or
90 minutes.
First double click
Second double click  60 minutes
Third double click
Fourth double click  No timed switch-off  One signal tone
Ending Finally press the heater button for 5 seconds. A long signal
programming: tone is output (2 s).
 30 minutes
 90 minutes
77
 2 Signal tones
 3 Signal tones
 4 Signal tones
01/2020