Télécharger Imprimer la page

solamagic Etherma Z1 Instructions De Montage Et D'utilisation page 73

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 84
Safety and operating instructions
Please observe the following instructions:
Carefully read through the instruction manual prior to installation and store the
manual safely.
This heater is intended for outside use by adults. It is not meant to be used for
indoor heating to create a pleasant temperature level.
Children must not play with the heater. Children younger than three years old
must be kept away from the heater unless they are continuously monitored.
Children younger than eight years old must not switch the heater on and off,
insert the plug in the socket, clean the heater nor perform any maintenance work.
Caution - Some parts of this product can become very hot and cause burns.
Special care is required when children and vulnerable persons are present.
• When carrying out any work, always switch the system to a zero-volt state
(disconnect mains plug; circuit-breaker off). Switch on the heater only after all
the cables have been completely connected.
• The heater must be protected with at least a 16A (slow) fuse.
• Do not mount the radiant heater close to curtains or combustible materials in
accordance with VDE 0100, Part 559.
• Do not install directly under sockets, junction boxes, switches or electrical
cabling.
• The heater is compliant to an IP 24 degree of protection, provided all con-
nectors (heater plug, plugs for expansion components) are plugged in, and is
approved for outdoor use.
• Never leave the heater unattended.
• Do not cover the heater when it is switched on or still hot; there is a risk of fire.
• To adjust the radiation direction, switch the heater off and allow to cool.
• Do not look directly at an operating IR halogen lamp for a long period and from
a short distance.
• IR halogen lamps are sensitive to direct skin contact (do not touch with bare
fingers). Grease or other contamination can be removed with an alcohol-so-
aked cloth.
• To maintain the service life of the IR halogen lamp, it must be protected against
vibrations, impacts and contaminants such as acids, ammonia, cement dust,
etc. .
• The IR halogen lamp must be protected against mechanical loading. It must be
replaced, if changes (dark spots, deformation) become apparent or the rated
73
01/2020

Publicité

loading