solamagic Etherma Z1 Instructions De Montage Et D'utilisation page 76

Operation
• NOTE: The transport lock in the reflector must be completely removed.
• NOTE: The device is equipped with an electronic safety off switch in the
event of an abnormal operating position.
• As supplied, the device is already programmed for the operating position (stan-
ding upright) and programmed with no timed switch-off.
• Acoustic signals confirm that the heater is operating. The heat output can only
be identified after a delay.
• Insert the device plug into the socket of the house installation and switch on the
house installation switch.
Switching
on/off: T he heater can be switched on or off by briefly pressing on the
heater button. Dependent on the programming of the switch-off
time:
• Single signal tone  Heating without timed switch-off
• 2 x signal tone
• 3 x signal tone
• 4 x signal tone
Short-term
heating: Double-clicking the heater button (signal tone) switches the
heater on for 5 minutes and then automatically switches it off
again.
- 30 minutes operation
- 60 minutes operation
- 90 minutes operation
76