Garland GRASS KEEPER 190 W Manuel D'instructions page 34

English
6.2.6. INSERT BATTERY AND KEY
6.2.7. REMOVING THE MULCHING PLUG
Lift the cover of the rear outlet, grasp the mulching
plug by the handle squeezing slightly until it pops out.
Then lower the rear outlet cover.
6.3. START UP
6.3.1. CHECK POINTS BEFORE START-UP
Do not use the machine if it is damaged or not well
regulated.
Use this machine to do jobs for which it has been
designed. Any other use could be dangerous to the
end user, for the machine and to other people, animals
and things that are nearby.
The electric current must conform to those stipulated
in the characteristics label on the machine.
Check all the machine and make sure that there are
no loose parts (screws, nuts, knobs etc) and any
damages to the machine.
Tighten, repair or replace all necessary equipment
prior to using the machine.
6.3.2. START UP
Before start up, ensure that all moving parts are not in
contact with any object.
Start up the machine carefully as per the instruction
manual and with your feet well clear of the blades.
Do not tilt the machine when starting the engine
unless it is necessary. In this case, do not tilt the
machine more than it is absolutely necessary and only
tilt the part furthest away from the end user.
Do not start the machine with your body in front of the
expelling area.
6.3.4. TURN ON AND TURN OFF
Turning on the machine:
Install the battery (see point 6.2.6)
Insert and turn the wrench attached to the accessory
bag
Press the safety button (1) and, without releasing it,
pull the switches (2) towards the handlebar. Then stop
pressing the safety button (1).
34/136