Garland GRASS KEEPER 190 W Manuel D'instructions page 27

When work must be carried out by two or more people
at the same time make sure you can control and
see the other people so as to maintain an adequate
working distance between users to guarantee security.
Maintain the workng area clean and work with good
light. Untidy working areas and dark conditions can
cause accidents.
Inspect the working area and remove all stones, wood,
cables and strange objects that could be touched and
propelled by the moving parts of the machine.
2.4. ELECTRICAL SECURITY
Use only Garland batteries for this machine. Use only
the Garland charger to charge the Garland batteries.
Using a different battery or charger may cause the
battery to explode and the risk of fire.
Be sure to connect the charger to a 230 V and 50 Hz
DC power source.
The electrical plug of the charger of this machine
must match the base of the socket.
Never modify the plug in any way. Unmodified plugs
and matching bases will reduce the risk of electric
shock.
When using the battery charger, avoid body contact
with grounded surfaces such as pipes, radiators,
electric ranges and refrigerators. There is an increased
risk of electric shock if your body is grounded.
Do not expose this machine, charger or
battery to rain or wet conditions. The water
that enters them will increase the risk of
electric shock.
Do not abuse the cable. Do not use the cable to carry,
lift or unplug the charger. Keep the cable away from
heat, oil, sharp edges or moving parts. Damaged or
tangled cables increase the risk of electric shock.
Never use this charger with the damaged cord or plug.
Before connecting the charger, check the plug and
cable for damage. If you discover any damage send
your machine to a technical service for repair. If the
cable is damaged or broken, unplug it immediately.
Damaged or tangled cables increase the risk of
electric shock.
The replacement of the plug or power cord should
always be done by the manufacturer or its technical
assistance service. It is recommended to connect this
charger to a residual differential device whose tripping
current is less than or equal to 30mA.
Never use a damaged connection base,
which does not comply with the regulations or the
requirements for this charger.
Disconnect the charger from the mains when it is not
in use to prevent damage in case of network overload.
Charge the battery only with the charger supplied
with the machine, in a dry place with a temperature
between 0º C and 40º C.
Do not attempt to tamper with or open the battery and
/ or charger.
Do not short-circuit the battery and be careful when
handling it so as not to accidentally short-circuit it with
conductive elements such as rings, bracelets, keys,
etc. When the battery is short-circuited it increases in
temperature and may explode or burn.
Do not attempt to burn the battery or incinerate it
even if it is damaged or completely discharged. Do not
leave the battery near a heat source. The battery can
27/136
English