KOBE IS2236SQF Manuel D'installation Et Mode D'emploi page 10

Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE
HOOD MUST BE PROPERLY GROUNDED.
MAKE SURE THIS IS DONE BY A SPECIALIZED
ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL
ELECTRICAL CODES. BEFORE CONNECTING
WIRES, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK
PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
6.
Connect three wires (black, white and green)
to house wires and cap with wire connectors.
Connect according to color: black to black,
white to white, and green to green.
7.
Test the operation of the hood before moving
on to next step. Make sure power is supplied
to the hood.
Ductwork Installation
Use 6" steel pipe (not provided) to connect
8.
the plastic exhaust on the hood to the
ductwork above.
9.
Use duct tape to make all joints secure and
air tight.
Duct Cover Installation
10.
Slide the duct cover up and secure the inner
duct cover to the telescopic stack with four
(4x8 mm) screws (provided). Refer to Figure
4.
AND LOCAL
SERVICE PANEL
Figure 4
TO
8