Proper Use; Items Supplied - KING CRAFT KCT 200 Mode D'emploi

Anleitung KCT 200
1
1. Description
1 Saw table
2 Saw blade guard
3 Push stick
4 Saw blade
5 Splitter
6 Table insert
7 Parallel stop
8 Motor
9 Power cable
10 Stand
11 On/Off switch
12 Cap
13 Toggle lever
14 Mitre stop

2. Items supplied

Carbide-tipped saw blade
Parallel stop
Angle stop
Push stick
Bench-type circular saw
Socket wrench
09.11.2001 10:35 Uhr Seite 9

3. Proper use

The KCT 200 bench-type circular saw is designed for
the slitting and cross-cutting (only with the angle
stop) of all types of timber, commensurate with the
machine's size.
The machine is not to be used for cutting any type of
roundwood.
The machine is to be used only for its prescribed
purpose.
Any use other than that mentioned is considered to
be a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting such cases of misuse. The machine is to be
operated only with suitable saw blades. It is
prohibited to use any type of cutting-off wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
GB
9