Technical Data; Before Putting The Machine Into Operation - KING CRAFT KCT 200 Mode D'emploi

Anleitung KCT 200
GB

5. Technical data

Asynchronous motor
Power rating
Temporary operation
Idle speed n0
Carbide saw blade
Number of teeth
Table size
Cutting height max.
Height adjustment
Table tilt
Connector for dust extractor
Size, complete
Packaging
Weight
6. Before putting the machine into
operation
The machine has to be set up where it can stand
firmly, e.g. on a work bench, or it must be bolted
to a strong stand.
All the covers and safety devices have to be
properly fitted before the machine is switched
on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
Cation! Always pull out the power plug before
carrying out any maintenance or conversion
work.
12
09.11.2001 10:35 Uhr
230 V 50 Hz
700 W
S3 50%
2800 rpm
200 x 30 x 2.5 mm
500 x 420 mm
43 mm / 90°
26 mm / 45°
infinite 0 - 43 mm
infinite 0 - 45°
dia. 35 mm
500 x 420 x 211 mm
512 x 444 x 290 mm
14 kg
Seite 12
7.1 Fitting the saw blade (Fig. 2)
2
20
Caution! Pull out the power plug.
Raise the saw table (1) to its top position
(see 8.3).
Undo the two hex screws (16).
Take off the chip box (15).
Undo the nut (17) with a size 19 wrench on the
nut itself and a second fork wrench (size 8) on
the motor shaft (a) to apply counter-pressure.
Caution! Turn the nut in the direction of rotation
of the saw blade (4).
Take off the outer flange (19) and pull the old
saw blade (4) off the inner flange (20) by
dropping the blade at an angle.
Clean the mounting flange (19 / 20).
Fit the new saw blade in reverse order.
Caution! Note the direction of rotation (see
arrow on the saw blade).
7.2 Adjusting the splitter (Fig. 3)
3