Cutting Narrow Workpieces - KING CRAFT KCT 200 Mode D'emploi

Anleitung KCT 200
GB
8.3 Adjusting the cutting height (Fig. 6/7)
6
7
Slacken the four thumb screws (28).
The saw table (1) can be raised or lowered to
adjust it to the required cutting height.
The cutting height can be read off the scale (x)
of the splitter (5).
Fix the saw table (1) with the thumb screws (28).
Important: Always tighten the thumb screws
securely to prevent the saw table dropping
accidentally.
8.4 Adjusting the angle (Fig. 7)
Undo the two thumb screws (27).
Swing the saw table (1) to the right and tilt to the
required angle using the scale on the angle
support (a).
Re-tighten the two thumb screws (27).
Important: Always tighten the thumb screws
securely to prevent the saw table dropping
accidentally.
14
09.11.2001 10:35 Uhr Seite 14
9. Sawing operations
After each new adjustment it is advisable to carry
out a trial cut in order to check the set
dimensions.

9.1 Cutting narrow workpieces

(width less than 120 mm) (Fig. 8)
8
Adjust the parallel stop (7) to the width of
workpiece you require.
Feed in the workpiece with two hands. Always
use the push stick (3) in the area of the saw
blade (4).
(A push stick is supplied with the saw!)
Always push the workpiece through to the end of
the splitter (5).
Caution! With short workpieces, use the push
stick from the beginning.
9.2 Cutting extremely narrow workpieces
(width less than 30 mm) (Fig. 9)
9