Troubleshooting - GigaAir 2020 Mode D'emploi

Troubleshooting

Troubleshooting Troubleshooting
Troubleshooting Troubleshooting
If you are not getting any signal at all If you are not getting any signal at all If you are not getting any signal at all If you are not getting any signal at all If you are not getting any signal at all
•
Check that the transmitter and receiver are properly connected to the audio/video components
from which you want to send/receive the audio/video s signal
•
Make sure that the transmitter is connected to the surce device and the receiver to the receiving
device
•
Check the power ON/OFF switches on the transmitter and receiver
•
Check power switches on the remote TV and video source (VCR, laser disc player, satellite receiver,
etc.).
•
Make sure power plugs are pushed all the way in.
•
Check all cable connections.
•
Check the CHANNEL switch on both transmitter and receiver are set to the same number
•
If you connect the receiver to a TV through an RF modulator, check that the TV is tuned to the
same channel as the TV Channel switch on the RF modulator (3 or 4)
If the signal is poor, or there is interference If the signal is poor, or there is interference If the signal is poor, or there is interference If the signal is poor, or there is interference If the signal is poor, or there is interference
•
Adjust the antennas orientation (see "Orienting Units for Optimal Performance", on page 15)
•
Change the channel on both transmitter and receiver and make them the same.
•
If there is a microwave oven in use in the path between the camera and monitor, remove the
microwave oven or turn it off
•
Make sure the transmitter and receiver are within range (up to 300 feet)
•
Check the channel dipswitch positions on the receiver
18