Auto-Sequence Function For Multiple Location Monitoring - GigaAir 2020 Mode D'emploi

Auto-Sequence Function for Multiple Location Monitoring

Auto-Sequence Function for Multiple Location Monitoring Auto-Sequence Function for Multiple Location Monitoring Auto-Sequence Function for Multiple Location Monitoring Auto-Sequence Function for Multiple Location Monitoring
The receiver's built in auto-sequence function is ideal for security use. The receiver can be used with up
to four cameras on four different channels and display them in sequence on a single TV/monitor. The
receiver's various operating modes are set via dipswitches as shown in the following diagram:
Dipswitches 1 ~ 4: Set up the automatic channel sequence function
Slide the channel dipswitch that you wish to view to the ON position.
Diswitch 5: Sets the sequence change interval time
ON: Changes channel every eight seconds.
OFF: Changes channel every four seconds.
16
Factory-Preset Mode