GigaAir 2020 Mode D'emploi page 33

Connecting to a TV With an Audio/Video Component
Receiver
Connecting to a TV Without Audio/Video IN Jacks
If your TV has UHF/VHF input only, and there is no audio/video
equipment near your TV, you will need to get an RF-Modulator
(available at your local electronic store) to convert the RCA jacks to
coax. Then select either channel 3 or 4 on your TV to view the video.
Receiver
VIDEO AUDIO
RF Modulator
VIDEO AUDIO IN
CH 3/4
VHF/UHF
RF OUT
Setting Up-Receiver Setting Up-Receiver Setting Up-Receiver
Setting Up-Receiver Setting Up-Receiver
Note:
If the TV has only one input
for audio (mono sound
TV
only), connect the white
plug to that single audio
input and to the receiver's
AUDIO LEFT jack.
If the jacks on the TV are
colored differently, connect
the yellow plug to the jack
labeled Video, the red plug
to the jack labeled AUDIO
RIGHT, and the white plug
to the jack labeled AUDIO
LEFT.
TV
9