jbc ADVANCED AD 2200 Mode D'emploi page 6

ENGLISH
Alignment
Important.
- It is essential to insert the cartridge till the end
for a good connection. Take the mark
reference.
Advanced series cartridge
Cartridge is made of the heating element which has the
heating system, temperature sensor and long life tip.
Long-life tip is basically made of:
1 Copper
2 Iron
3 Chromium
4 Tin plate
Long-life tip care
Except for the copper core, the rest of metals are
placed galvanically on layers relatively thin, so it
is necessary to avoid the reasons which can
cause its destruction.
To clean the tips, use the sponge included with
the stand and check it is slightly moisted.
Only deionised water (car battery water)
should be used in order to wet the sponge. If
normal water was to be used, it is very likely that
the tip will become dirty due to the salts dissolved
within the water.
To re-tin the soldering tips, we recommend using
the tip tinner/cleaner TT 9400 ref. 9400000.
Fume extractor accessories
For handpieces 2045/2245:
Standard Ref.0495000
+20mm longer Ref.0455002
Specially designed for the Advanced Series
handpieces 2010/2210 and 2045/2245. Easily clips
onto the handpiece and can be quickly removed
for easy maintenance.
For handpieces 2010/2210
Ref.0265000
Temperature sealing-cover
Accessory which replaces the
selection temperature button and
it is use to prevent operators
from changing the temperature
that has been pre-selected.
Indicates the
temperature.
Console AC 2600
a s
AC 2600
Ref. 2600000
The console AC 2600 is designed for modifying the
original regulation program parameters of the following
Advanced control units:
- AD 2000 soldering station.
- AD 2200 soldering station.
- AD 4200 and AD 4300 dual soldering stations.
- AR 5500, AR 5800 (*) and DS 5300 (*) desoldering
stations.
- AM 6000 and AM 6500 (*) rework stations.
(*) These stations need a console whose
program version is 4.0 or higher.
Changes avalaible to perform:
- Fixing the the working temperature.
- Selection of temperature units in Celsius grades
-°C- or Fahrenheit -°F-.
- Modification of sleep temperatures and standby
times.
- Adjustment of temperature.
- Set the parameters back to the original parameters.
- Read-out data:
Working hours.
Sleep cycles and sleep hours.
Cartridge and iron changes.
Program version.
JBC reserves the right to make technical changes without
prior notification.
4
0261410
selected