Lcd Tv And Operating Buttons; Viewing The Connections- Back Connectors - CONTINENTAL EDISON 22FHD3 Mode D'emploi

LCD TV and Operating Buttons

FRONT and REAR VIEW

Viewing the Connections- Back Connectors

1. SCART socket inputs or outputs for external devices.
Connect the SCART cable between SCART socket on TV and
SCART socket on your external device (such as a VCR or a DVD
player).
Note: If an external device is connected via the SCART socket,
the TV will automatically switch to AV mode.
2. PC Input is for connecting a personal computer to the TV set.
Connect the PC cable between the PC-VGA INPUT on the TV
and the PC output on your PC. Component Video Inputs (YPbPr)
are used for connecting component video.
You can use PC-VGA input to enable YPbPr signal connection
with a device that has component output. Connect the YPbPr to
PC cable between the PC INPUT on the TV and the component video outputs of your device.
3. SPDIF Coaxial Out
bypassed while in media browser mode only.
4. RF Input connects to an antenna or a cable system.
Note that if you use a media recorder, you should connect the aerial cable through the device to the
television with an appropriate antenna cable, as shown in the illustration in the following pages.
5. HDMI 1: HDMI 1 input
HDMI Input is for connecting a device that has an HDMI socket.
Your LCD Television is capable of displaying High Definition pictures from devices such as a High
Definition Satellite Receiver or DVD Player. These devices must be connected via the HDMI sockets
or Component Socket. These sockets can accept either 480i, 480p, 576p, 576i, 720p, 1080i, 1080p
(Optional) signals. No sound connection is needed for an HDMI to HDMI connection.
When you use the wall mount kit (optional) with the LCD TV, we would definitely recommend to plug all your cables into the
back of the LCD before mounting to the wall.
outputs digital audio signals of the currently watched source. Dolby D Audio is
English - 38 -
SIDE VIEW Control Buttons
1. Up button
2. Down button
3. Programme/Volume / AV
selection button
4. Standby / On button
Note:You can use "+/-" buttons to
change volume. If you want to change
channels, press P/V/AV button once
and then use "+/-" buttons. If you hold
the P/V/AV button about a few seconds,
source OSD will be displayed. Main
menu OSD cannot be displayed via
control buttons.