Meec tools 018633 Mode D'emploi page 45

• Tighten the screw (6).
USE
WARNING!
Risk of personal injury. Allow the product to
idle for a few seconds before use. Replace the
disc immediately if it vibrates.
Only use the product with the support handle
and a correctly adjusted guard.
CHECKS BEFORE STARTING
Always check as follows that the product is in
safe condition before use.
• Check the product for visible damage.
• Check that all parts are fitted correctly.
STARTING / STOPPING
WARNING!
Risk of personal injury. The grinding
accessory continues to rotate for a few
seconds after the product has been switched
off. Wait until all moving parts have
completely stopped before putting down the
product.
NOTE:
An undervoltage relay trips in the event of
a power cut, which prevents the product
starting when the power is restored.
To start the product, switch if off and then start
it again with the power switch.
FIG. 4
• Push the start inhibitor (2) forward and
press the power switch (1).
• Switching off: Release the power switch (1).
TIP
WARNING!
Risk of personal injury. Do not attempt
to grind with cutting discs. Only use the
recommended part of the disc.
• Cutting discs are intended to cut with the
periphery of the disc.
• Grinding discs are intended to grind with
the side of the disc.
IMPORTANT:
Risk of personal injury. The rotating accessory
and the workpiece get very hot when in use.
Do not touch the rotating accessory or the
workpiece before they have cooled.
• Secure the workpiece.
• Do not tilt the product when cutting.
• Do not press too hard on the product.
MAINTENANCE
CLEANING
• Clean the product at regular intervals,
depending on conditions of use.
• Use a vacuum cleaner or brush and clean
dust off the ventilation openings on the
motor. Wipe the product with a damp
cloth.
STORAGE AND TRANSPORT
WARNING!
Risk of personal injury. Store the product out
of the reach of children and unauthorised
persons.
IMPORTANT:
Risk of material damage. Do not store the
product in damp conditions or unprotected
outdoors.
• Clean the product before putting it into
storage.
EN
45