Service Programmes - Siemens CT636LE.6 Mode D'emploi

en

Service programmes

■ Remove the cover of the brewing unit and
clean thoroughly under running water�
■ Clean the strainer of the brewing unit
thoroughly under the water jet�
■ Thoroughly clean the connecting nozzles
of the brewing unit�
L
Important: Clean it without using
washing-up liquid and do not put it in
the dishwasher�
■ Clean the inside of the appliance thor-
oughly with a moist cloth, removing any
coffee residues.
■ Leave the brewing unit and the inside of
the appliance to dry�
■ Place the cover back on the brewing unit�
54
■ Push the brewing unit all the way into the
appliance and press on the middle until it
audibly clicks into place�
F
Important: The red latch must be
right over at the left at j before
replacing (see diagram E)�
■ Press the eject lever right up and push
the red latch right over to the right to k�
■ Insert the coffee grounds container.
■ Replace the protective cover.
■ Close the appliance door�
Service programmes
(see also the Quick reference guide)
The following messages will appear on the
display at certain intervals, either
"Descaling programme urgently required!"
or
"Cleaning programme urgently required!" or
"calc'nClean programme urgently required!"�
The unit should immediately be cleaned or
descaled using the appropriate programme�
Alternatively, the two processes Descale
and Clean can be carried out together using
the calc'nClean function (see the section
"calc'nClean")� Failure to carry out the
service programme according to the instruc-
tions may damage the appliance�
F
Important: If the appliance is not
descaled when it is supposed to be,
the message "Descaling programme
is overdue. Device will shortly be
locked." will appear� Immediately
perform the descaling process in
accordance with the instructions� If
the appliance is locked, it can only
be operated again once the descal-
ing process has been carried out�
To display how many beverages can still
be prepared before one of the service pro-
grammes needs to be run, proceed as follows:
■ Press button E
■ Turn the rotary selector to select
"Service info"�
■ Touch [ Display ] to call up the information�