Télécharger Imprimer la page

Summit Treestands Viper Level Pro SD Mode D'emploi page 6

Publicité

Les langues disponibles

Les langues disponibles

4
SETUP
(ALL TREESTAND MODELS)
SEAT
Your foam seat must be attached to the climber platform
before use. The straps and buckles are attached and buckled
on the bottom of the seat from the factory. Please unbuckle
before proceeding.
1. Place your seat platform on a flat surface with the
rear "V" brace facing up.
2. Position the seat inside of the seat platform frame.
3. Wrap the seat strap webbing over the frame from the
inside out as shown in figure 1.
4. Turn the three bar slide slightly sideways and push it
through the metal D buckle that is sewn onto the end
of the strap (figure 2).
WARNING
!
Replace all seat cushions every two (2) years or
sooner if damage or wear is present.
RAPIDCLIMB STIRRUPS
Adjust the stirrups to fit your footwear at ground level.
This is done by loosening the wing-nut and sliding the stirrup
up or down the tube. Re-tighten the wing-nut once desired
fit is achieved. NEVER remove the wing-nut or stirrups.
NEVER slide the stirrup outside of the acceptable adjustment
range showed in figures 3a and 3b.
WARNING
!
Moving your foot placement closer to the tree changes
the leverage needed to adhere the platform to the tree.
Attaching the stirrups or placing your feet too close to the
tree may cause the platform to slide down the tree which
could cause serious injury or death. See figure 3a and 3b
for proper foot location.
BACKPACK STRAPS
1. Loop the middle section of the shoulder straps under the desired platform brace and pull both ends through the loop and tighten as
shown in figures 4a and 4b.
2. Take the unattached adjustment strap and place the loop end around the platform frame as shown in the picture and pull the
free end through the loop as shown in figure 5.
3. Attach the free end to the should strap buckle as shown in figure 6a and adjust to the desired length of strap as shown in figure 6b.
Repeat steps 2-3 for second adjustment strap.
4a
PG 6
4b
1
The seat included with these treestands is removable
for storage. DO NOT leave your stand outdoors
when it is not being used.
3a
3b
5
2
NOTICE
6a
www.summitstands.com
ACCEPTABLE
ADJUSTMENT
RANGE
6b

Publicité

loading