Mettler Toledo InPro 6000 Instructions D'utilisation page 22

en
22
Article Nr.: Electrolytes
59 907 065 – O
52 206 107 – O
30 298 424 – O
30 298 425 – O
a
Warning: The O
Contact of electrolyte with mucous membrane or eyes is
to be avoided. Therefore protective gloves and safety
glasses have to be worn for the following dismantling
works. If such contact occurs, the affected area should be
well rinsed with water. In the case of accident, or should ever
any adverse signs appear, get immediate medical attention.
4 Installation
4.1 Connection
The sensors are installed to a transmitter by using a VP
(analog sensors) or AK9 (ISM sensors) connector cable.
Cables in different lengths 2 – 50 m are available from
METTLER TOLEDO.
h
Notice: Cable and terminal assignment can be found in
the METTLER TOLEDO cable and / or transmitter instruction
manual.
O
4.2 Mounting the sensor
Before mounting the sensor into a housing remove the
protection cap on the sensor. The sensor can then be mounted
into an InFit / InTrac Series housing from METTLER TOELDO.
Alternatively, the 12 mm sensors can be mounted directly
through a socket with inside thread Pg 13.5 and securely
tightened via the Pg 13.5 threaded sleeve.
h
Notice: For connecting the cable to the terminals of the
transmitter, please refer to the instructions given in the
METTLER TOLEDO transmitter manual (www.mt.com/pro-
transmitters)
© 03 / 16 Mettler-Toledo GmbH
30 313 395
Electrolyte 25 mL (InPro 6050;
2
InPro 6800; InPro 6850 i; easySense)
Electrolyte 25 mL High Salinity
2
{InPro 6900 (i); InPro 6950 (i)}
electrolyte pack 3 × 25 mL
2
(InPro 6050; InPro 6800; InPro 6850 i;
easySense)
electrolyte pack – high salinity 3 × 25mL
2
{InPro 6900 (i); InPro 6950 (i)}
electrolyte has an alkaline pH value.
2
VP connector
K8S (ISM)
Transmitter
2
InPro 6000 Aperometric O
Slit Pin
VP or AK9 cable
Amperometric Sensor Series
2
Plug VP-6 cable
AK9 (ISM)
Printed in Switzerland
Sensors