Automated Learning Process./ Activating Code; Remote Control Operation; Testing Your Fan - Craftmade Fresco FRS52-LED Guide D'installation

11. Automated Learning Process./ Activating Code.

CAUTION :
The wall and/or handheld remote control can be programmed to multiple receivers or fans.
If this is not desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall control, press and hold the OFF button on the
wall control for 5 seconds (or until light blinks twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back on. Within 60 seconds of
restoring the power, press and hold the OFF button on the front of the handheld remote control
for 5 seconds (or until light blinks twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is complete-- see Section 13 below.

12. Remote Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button
- turns fan to LOW speed
OFF button
- turns fan OFF
L1 button - turns light kit ON/ OFF when pressed once;

13. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test wall control (optional installation)
by locating ON/ OFF slider switch on wall control, then set to
the ON position. Test light and dimmer function and then
test fan speeds. Next, locate handheld remote control. Test
the light ON/ OFF function by pressing the L1 button; test the
dimmer function by pressing the L1 button and holding it
down for up to 5 seconds. Test fan speeds with the different
fan speed buttons. If the wall and/ or handheld remote control
operate(s) all of the functions of the fan and light, battery/
batteries has (have) been installed correctly. If the wall and/
or handheld remote control do (does) not operate all of the
fan/ light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Turn fan completely off before moving the reverse switch
(located on top of motor housing). Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer ( diagram 1 )
- RIGHT position in winter ( diagram 2 )
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without
feeling a difference in your comfort.
Important : Reverse switch must be set either
or completely RIGHT for fan to function. If the reverse switch is
set in the middle position ( diagram 3 ), fan will not operate.
NOTE : If the wall control/ handheld remote control interferes
with other appliances, turn off power first and then go back
to the instructions in Section 11 above.
(switch not functional on handheld remote)
dims light kit when pressed and held down
completely LEFT
reverse
switch
diagram 1
page 11
- 1 1
wall control
handheld
remote control
motor
housing
- 1 1
diagram 2 diagram 3