Manual: BeamBar Series
8. Operation
1.
Connect the power cable to the device and then to the mains
2.
Insert key and turn it ‚ON'
3.
Please make sure, that the Interlock adapter is inserted
4.
Select mode:
Your device runs in auto mode:
•
Your device runs in music mode:
•
Control the music-sensitivity by the trim pot at the rear side of the device.
Your device runs in manual mode:
•
Select effect
Your device runs in DMX mode if '10' is switched off:
•
Set the DMX address
Connect a DMX controller to operate the laser.
page 8 / 27