General use
Do not block vent holes in the front panel.
Do not damage the refrigeration system parts.
During normal operation, some parts of the refrigeration system in the
compressor compartment might reach high temperatures, and could therefore
cause burns if touching these components.
Do not use electrical devices inside the cabinet.
To ensure correct and efficient air flow in the cabinet, the shaded areas must be
kept free of products. (see Fig. 5)
All products to be stored, that are not wrapped or packed, must be covered in
order to avoid unnecessary corrosion of the inner parts of the cabinet.
If any controller parameters are changed from default, this could cause that the
appliance is not functioning normally, and harmful temperatures could damage
products that are kept inside the appliance.
If the appliance is turned off, wait minimum 3 minutes before turning the
appliance on again. This is to protect the compressor from damage
Be aware, if bottles are stored near the air outlet, they may freeze up and break, causing a
risk of injury.
Do not pack the cabinet with foods. Allow some space between them to ensure a good
airflow.
Moist or fresh foods and those with a strong smell should be wrapped up in a plastic film or
packed in a container. Otherwise the food may dry up or give their smell to other foods.
Foods containing acetic acid or yeast should be wrapped up in plastic film. Otherwise they
may accelerate corrosion of the evaporator and metal parts, resulting in failure.
765041480
Rev. 000
34