Makita PM7650H Manuel D'utilisation Et De Sécurité page 20

Installing and removing the dispersion cover
To install the dispersion cover (1), mount the dispersion cover on the top nozzle (2)
so that its protrusion (3) is aligned with the notch (4) in the top nozzle.
Secure the dispersion cover by turning it fully clockwise.
To remove the dispersion cover, follow the above procedure in reverse.
Changing the nozzle to a small-amount-solution-discharge
nozzle (optional accessory)
When a small amount of solution needs to be sprayed, replace the nozzle cap with
another type of supplied nozzle cap with a small discharge hole.
To replace the nozzle, follow the procedure below.
1. Remove the screw (1) from the second nozzle (2) and then remove the top
nozzle (3) and dispersion cover (4).
2. Fit a slotted bit screwdriver to the slit (5) in the nozzle top and remove the nozzle
cap (6) by turning it fully counterclockwise.
20
(2)
(4)
(1)
(3)
(2)
(3)
(4)
(1)
(5)
(6)