Atlas Copco LH 11 Consignes De Sécurité Et D'utilisation page 9

LH 11, 180, 190, 220, 230, 270, 280, 390, 400
WARNING Hydraulic oil at high pressure
Thin jets of hydraulic oil under high pressure can
penetrate the skin and cause permanent damage.
Immediately consult a doctor if hydraulic oil has
►
penetrated the skin.
► Never use your fingers to check for hydraulic fluid
leaks.
► Keep your face away from any possible leaks.
WARNING Hydraulic oil
Spilled hydraulic oil can cause burns, accidents due
to slippery conditions and will also harm the
environment.
Take care of all spilled oil and handle it according
►
to your safety and environmental regulations.
► Never dismount the hydraulic machine when the
hydraulic oil is hot.
Never run any hydraulic lines for attachment of
►
the hydraulic machine through the drivers cab.
CAUTION Skin eczema
Hydraulic oil can cause eczema if it comes in contact
with the skin.
► Avoid getting hydraulic oil on your hands.
Always use protective gloves when working with
►
hydraulic oil.
Wash hands after contact with hydraulic oil.
►
CAUTION Moving parts
Risk for crushed hands and fingers.
Never check bores or passages with hands or
►
fingers.
Operation, precautions
DANGER Explosion hazard
If an insertion tool comes into contact with explosives
or explosive gases, an explosion could occur. When
working on certain materials and when using certain
materials in machine parts, sparks and ignition can
occur. Explosions will lead to severe injuries or death.
Never operate the machine in any explosive
►
environment.
Never use the machine near flammable materials,
►
fumes or dust.
► Make sure that there are no undetected sources
of gas or explosives.
© 2011 Atlas Copco Construction Tools AB | No. 3392 5206 90b | 2011-01-27
Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
WARNING Operating pressure
If the maximum operating pressure for the hydraulic
machine is exceeded, the accumulator can be over
charged which can result in material damage and
personal injury.
Always run the hydraulic machine with the correct
►
operating pressure. See "Technical data".
WARNING Unexpected movements
The inserted tool is exposed to heavy strains when
the machine is used. The inserted tool may break
due to fatigue after a certain amount of use. If the
inserted tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Furthermore, losing your balance or slipping
may cause injury.
Make sure that you always keep a stable position
►
with your feet as far apart as your shoulder width,
and keeping a balanced body weight.
► Always inspect the equipment prior to use. Never
use the equipment if you suspect that it is
damaged.
Make sure that the handles are clean and free of
►
grease and oil.
Keep your feet away from the inserted tool.
►
► Stand firmly and always hold on to the machine
with both hands.
Never start the machine when it is lying on the
►
ground.
Never 'ride' on the machine with one leg over the
►
handle.
► Never strike or abuse the equipment.
Check regularly for wear on the insertion tool, and
►
check whether there are any signs of damage or
visible cracks.
Pay attention and look at what you are doing.
►
9