Vacmaster Professional VK811PH Manuel D'utilisation page 12

LIQUID VACUUMING
WARNING:
ENTITLED "IMPORTANT SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS
WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL,
OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO:
COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE THE RISK OF HEALTH
HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS.
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
1. Verify that the power cord is disconnected from the outlet. Make sure that the collection tank is
clean and free from any debris or hazardous waste (Fig. 1).
3. Rinse the inside of the collection tank to remove any loose debris and dispose of liquid in
suitable container.
DO NOT USE THE HEPA CARTRIDGE FILTER AND THE MICROFIBER PRE-FILTER FOR
LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
5. Push the required attachment onto the free end of the hose or extension wand. To use the
round dust brush and crevice tool with an extension wand you will be required to use the metal
accessory adapter (Fig. 3 & 4).
6. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power
outlet. Plug the power cord into the outlet (Fig. 5 & 6).
power cord from the outlet.
outside of the collection tank (Fig. 8).
IMPORTANT!
outside before storage.
REMEMBER!
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
DO NOT PLUG THE POWER CORD INTO THE POWER OUTLET. MAKE
12