Johnson Controls ChillPAC Mode D'emploi page 60

1. Open the tightening screw (pos. 1) on the meta glass connector and the fixing screw (pos. 2),
see Fig. 27.
2. Fit it carefully on the process connector. The loose screw (pos. 1) gives way for the trapped air
so the signal converter can be installed. It should be pressed down carefully, yet with some
force, to fit over the o-ring.
3. Now tighten both screws carefully according to the AKS instructions.
4. When power is connected, and the screen is starting up, do a quick set-up according to the in-
structions in Fig. 28.
AKS 4100
Enter menu system Unit change at
Enter QUICK SETUP distance/level
readout:
m, cm, mm, in, ft
• Connect the device to the power supply Connect the device to the power supply
(see the section "Electrical installation/
connection").
• Press 3 times.
AKS 4100
QUICK SETUP ?
YES NO
• Press
AKS 4100
D22
• Press or to select between SINGLE,
COAXIAL D14 and COAXIAL D22. Choose
D22 and press
AKS 4100
CO2?
YES
• Press
AKS 4100
PROBE LENGTH
00280 mm
Fig. 28: Quick set-up of AKS 4100 280 mm
*
Note:
The signal converter can be programmed with or without mechanical process
connector assembled.
To con gure the signal converter, a HMI display is always needed.
Change between:
Distance*
Level**
Output (%)***
Output (mA)****
• Press to change the PROBE LENGTH.
Press to change the position of the
cursor.
Press to decrease the value or
increase the value.
Press
AKS 4100
SCALE 4 mA
• Press to change of SCALE 4 mA.
Press to change the cursor position.
Press to decrease the value or
increase the value.
Press
AKS 4100
SCALE 20 mA
NO
• Press to change of SCALE 20 mA.
Press to change the cursor position.
Press to decrease the value or
increase the value.
Press
to
• Wait for QUICK SETUP to complete.
Count down from 8 sec.
210 mm
• Press
to
• Press
STORE NO or STORE YES.
00060 mm
Press
Default screen appears:
DISTANCE
to
QUICK SETUP completed
Mode d'emploi - ChillPAC et LP ChillPAC Mk 3
60/69
Annexes
AKS 4100
QUICK SETUP
COMPLETED IN 8
AKS 4100
AKS 4100
1.0.0
QUICK SETUP ? QUICK START
YES NO
AKS 4100
1.0.0
STORE NO
or to select between
AKS 4100
XXX mm
010823 fr 06/2021