Oregon OR25TBS-1 Manuel D'instruction page 21

Step 6:
6a: Remove the plastic dust cap located in the end of the suction tube and loosen hose clamp .
6b: Slide hose onto the suction tube located on the bottom of the hydraulic pump and tighten clamp .
6c: Locate the two pressure hoses and remove the caps located in the ends .
6d: Take the hose with the 90 degree end and attach it to the round filter cover and tighten as shown .
6e: Attach the other end to the valve assembly as shown .
6f: Take the remaining hose and attach it to the pump and tighten as shown .
6g: Attach the other end to the valve assembly as shown .
Note: Hose connectors are designed to only fit on the proper connection and cannot be connected to the incorrect location .
Item Description
1 Suction Hose
2 Return Hose
3 Pressure Hose
2 3
1
Quantity
1
1
1
Assembly Instructions
21