Oregon OR25TBS-1 Manuel D'instruction page 20

Assembly Instructions
Step 5:
5a: Locate the engine and pump assembly and remove the two hold down bolts .
5b: Place motor/pump assembly onto the engine plate located on the tank assembly .
5c: For the 25T and 30T models
Locate (4) M8 x 40 bolts, (8) #8 flat washer, (4) #8 lock washers and (4) M8 nuts, from the hardware kit .
For the 35T models
Locate the (4) M10 x 45 bolts, (8) #10 flat washer, (4) #10 lock washers and (4) M10 nuts, from the hardware kit .
5d: Install as shown and tighten .
6
5
4
1
20
2
4
3
Item Description
1 Log Splitter Assembly
2 Engine and Pump Assembly
25T & 30T
3 M8 x 40 Bolt
4 M8 Flat Washer
5 M8 Lock Washer
6 M8 Nut
35T
3 M10 x 45 Bolt
4 M10 Flat Washer
5 M10 Lock Washer
6 M10 Nut
Quantity
1
1
4
8
4
4
4
8
4
4