EUROM PAC 7.2 Manuel D'utilisation page 21

Dehumidification
 To use the dehumidification function, connect the water drain hose to the
water drainage point (9). This hose should lead to a bucket or drain. The hose
should not run upwards! Your unit is now ready for use.
Caution: When using dehumidifier mode, the outlet hose hot air also needs to
be placed outside. The moisture the device extracts from the air inside the room
is pulled outside through the air drain hose. The remaining moisture is only
drained using the drainage valve if not all of the moisture can be led outside
through the drainage hose.
Cooling
 In order to use the cooling function, you do not need to connect the water
drainage hose. Place window kit in the window opening, see diagram. The length
of the window kitl can be adjusted from 67.5 to 123 cm.
 Screw on the connector for the air conditioner on one end and the connector for
the window panel on the other end of the outlet hose.
 Slide the connector for the air conditioner into the appropriate slot on the rear of
the unit.
 Secure the other end of the outlet hose in the window panel opening so that it
can remove hot air outside.
 You can also hang the outlet hose out of an open window; this method is less
efficient however.
 Avoid bends or pinches in the pipe. These will lead to a build-up of damp, waste
air which can cause leaks, overheating or lead to the air conditioning unit
switching off.
 Don't forget about preventing access to burglars!
21